I have listed some of the most typical boiler breakdown problems below to obtain the boiler backup and working.
You wake up one morning looking to jump in the shower and then find you have no warm water, you go and check the boiler and notice a fault code is showing on the display, so what do you do?
You need to find out what the fault code is and why it has made the boiler breakdown.
All boilers are given a users manual, inside this manual will be listed all of the fault codes and the explanation for the code to show.
The fault code reason is only a guide on which to check on for, sometimes it can be a combination of problems, but it is a starting place to trace the problem.
Sometimes it's a quick fix simply by pushing the reset button, other times it can be a bit more involved.
Extra resources|Find more info could possibly be avoided just by maintaining your boiler regularly.
All boiler manufactures recommend having a boiler service carried out each year to help keep the boiler working since it was designed for.

A boiler can be like a car engine, if left un-serviced it will eventually breakdown and may possibly be costly to correct.
One of the most common boiler problems is low water pressure, that is caused by the water within the entire system dropping to a spot where the boiler sensor senses low water and throws up a fault code and locks the boiler out.
Low water pressure often means many things, it may be a leak somewhere on the system, a radiator valve leaking or even a leak on a pipe somewhere.
The most common response to this problem may be the expansion vessel. If your boiler has been dealing with no problems going back after some duration, then all of a sudden you see the water pressure should be topped up every now and then, the chances are the expansion vessel needs checking.
The expansion vessel is similar to a balloon, over time it will loose its pressure and water will enter the vessel, once this happens you could have a boiler breakdown with a fault code displaying on the boiler screen.
The expansion vessel is really a very important area of the boiler and must be maintained every year.
Another common boiler breakdown is due to dirty water, this is caused when no inhibitor is put into the system water.
You may have noticed if you've ever vented a radiator that the water is very dirty as it pertains out of your vent, this normally indicates no inhibitor within the system, even though inhibitor was added, overtime it'll dilute down and can must be topped up, this should be checked every year.
The dirty water will eventually block up the boiler heat exchanger, this cause the boiler to overheat and go to lockout.
Perhaps you have encounter a boiler breakdown if it is snowing outside even freezing?
Most boilers nowadays are condensing boilers, and when the boiler is working it produces condense.
The condense must exit right into a drain, internally is preferable, but sometimes the condense pipe would go to another drain, if this is actually the case the pipe should be protected from the cold with pipe lagging.
Should the condense pipe freeze over, the condense will start to back up into the boiler and eventually the boiler will breakdown, with a fault code displaying on the boiler display.
These are just a couple of the most common boiler breakdown faults that could be avoided if only you'd the boiler serviced.
Boilers do breakdown even when serviced each year, however, not just as much as a boiler not serviced.
Will have your boiler serviced each year by a Gas Safe Registered company, don't use Joe Bloggs from down the road just because he could be cheaper.
All Gas Safe Engineers have to re-sit their gas exams every five years to carry on working within the gas industry.
I hope this advice can help you keeping in mind your boiler working and producing all the heat and hot water you need.